How to Clean the Heater Core?

How to clean the heater that you will do at regular intervals in order for the honeycombs to work more efficiently and give heat, and tips.

General Cleaning

• Vacuum cleaner;
• Detergent;
• Brush;
• Micro fiber cloth;
• That.

Heating pads will cause contamination over time due to dust accumulation or other reasons. Since dirt deposits visually disturb many people, it is very important to clean the radiator every two months without interruption.

You can clean it together with the materials in your home to prevent contamination. For this, you will need the materials we wrote above. To remove dust residue first, you should vacuum it with the vacuum cleaner.

One of the points you should pay attention to is that invisible dust will accumulate between the honeycombs in time, and after a while, these dust will accumulate and cause a black and bad image.

After vacuuming with a vacuum cleaner, it will be important to brush the corners and inner parts of the honeycombs together with a brush with bristles, in case you disrupt the cleaning. A microfiber cloth that you slightly moistened should be wiped. Detergent water should be prepared in a bowl and after wetting a clean cloth with detergent water, wiping should be applied again.

Finally, in order to avoid detergent stains, you should be wiped with a clean and damp cloth and then dry. General cleaning should not be interrupted and should be done at certain intervals.

Radiator Cleaning with Vinegar

• 1 cup of vinegar;
• 1 liter of water;
• Spray bottle;
• Hair dryer;
• Detergent;
• Cloth.

Those who have small children or are sick at home should pay more attention to hygiene. For this reason, you can definitely use vinegar to clean the radiator to eliminate germs. Since vinegar has germicidal properties, you should clean it using pure vinegar.

First of all, you should clean the dust. You can use a vacuum cleaner as well as a hair dryer to remove even the dust left in the corners. The hair dryer should be held all over the comb to prevent the formation of very intense black spots upon build-up.

In order to ensure hygiene together with the removal of the dust, firstly, 1 glass of pure vinegar you will fill into the spray bottle and rinse it by pouring warm water on it. After spraying on the honeycomb from a distance of 20 centimeters and waiting for 30 minutes, you should prepare detergent water in a bowl and then rinse it with a clean cloth after wiping with detergent water.

After your drying, you will easily ensure the hygienic cleaning of the combs thanks to this method.

Internal Cleaning of Honeycombs

In order to make the heater work more efficiently, the inside of the combs should be cleaned every 5 years without interruption. Failure to clean it will cause heat loss as well as contaminate your curtains and walls. Many people cannot clean honeycomb in their homes. They get help from an expert for this. If you have materials in your home, you can do this cleaning yourself. First of all, the materials you need are:

• Wrench;
• Hose;
• Basin;
• Special honeycomb cleaning fluid;
• Lots of water.

Care should be taken to keep the combi off in cleaning the core. In order to drain the water in the combs, the drain valve should be opened, first the excess water will flow, and then the less incoming water is expected to drain completely.

Make sure that the valves on both the bottom and the top of the pads are closed. When opening the connection point with the help of a suitable wrench, some water remaining in the honeycomb can be seen to flow. For this reason, you should put the bowl under it with the wrench before opening it to prevent it from leaking to the floor. When you open it with the help of a key, you should remove the combs as a result of the small amount of water remaining in it.

You should be very careful not to damage the connection points during the removal of the honeycombs. When cleaning the interior, move the combs to the bathroom or toilet, as water will flow like tar. You must keep it upright. Turn on the water by placing a long hose at the top of the honeycomb. When you turn on the water, black colored dirt will start to flow from the hole at the bottom. This pitch, which was very dark at first, will lighten in a few minutes. Do not turn off the water until the color of the water is completely clear.

There are special cleaning fluids used in honeycomb cleaning. These contain anti-limescale and detergent. Close the drain part and pour some liquid from the hole above and add water to it. Wait for 10 minutes and do not turn off the water until you give clean water again and make sure that the detergent is completely out of the pad.

Carefully mount the honeycomb back to the wall-mounted part and then connect the connection points with a wrench. You should not open your boiler until all honeycomb cleaning is finished.